Flexible and Portable >> Mining Cable


 Type MP-GC EPR


TYPE MP-GC POWER FEEDER CABLE - 5000/8000/15000 Volt, EPR Insulation, CPE Jacket, Stranded Copper Conductor, 90°C Dry, Wet

Type MP-GC cables are three conductor mine power feeder cables with two ground conductors and one ground check conductor. Mine power feeder cables are recommended for use as primary power distribution cable in mines, mine tunnels and properly supported in shafts. MP-GC is used in bore holes, for aerial suspension, directly buried, in ducts and other semi-permanent mining and industrial feeder applications. This cable may be used in wet or dry location at continuous conductor temperature of 90°C. This cable is constructed of Ethylene-Propylene Rubber (EPR) insulation and chlorinated polyethylene (CPE) jacket.

  • Excellent heat and moisture resistance
  • Resistant to most oils and chemicals
  • Flame retardant
  • Meets MSHA flame test requirements
  • OSHA acceptable; MSHA accepted
  • Maximum continuous conductor temperature: 90°C DRY, 90°C WET

  • Type MP-GC EPR
    Application: High voltage distribution circuits for permanent installations in bore holes, shafts, open pits, strip mines and tunnels
    PrintRequest


    Specifications listed are from multiple manufacturers. The items above represent only a portion of the products available. For specific manufacturer technical information or for an item not shown, please contact a Calvert Wire cabling specialist at 800-837-2668.